You can use supplied Cable Ties to organize your wires and power cords.

2. Before using the robot on a rug with tasseled edges, please fold the rug edges under.

3. Keep robot away from wet areas, such as kitchen or bathing room.Robot would be damaged by water.

4. The round bases of certain bar chairs, pedestal tables, pedestal fans, and floor lamps can affect the robot's mapping and navigation. 

    Therefore, during robot cleaning, please remove these items with round bases, or set this area as a "NO-GO Zone" or apply a "Virtual Wall" using the Tuya Smart app.

5.  The bottom clearance of the furniture should be less than 2.56 in (65 mm) or greater than 3.74 in (95 mm) from the ground. 

     Clearances within this range may cause the robot to get stuck, such as under sofas, cabinets, or other furniture. 

     Please set such areas as "No-Go Zones" or configure "Virtual Walls" using the instructions on page 39, to prevent the robot from becoming trapped.

6. The anti-drop sensors will generally prevent the robot from tumbling down stairs and steep drops. 

    However, they may be less effective if they are dirty or used on carpeted, reflective, or very dark-colored floors. 

    It is recommended to place a secure physical barrier to block off areas where the anti-drop sensors are less effective as described above.

7. During the first use, make sure each room door is open to help Robot fully explore your house.

8. Since the robot can cross thresholds up to 0.6 in / 15 mm high, if any room's outer threshold is less than 0.6 in / 15 mm, 

    but the threshold measured from the inside of the room is higher than 0.6 in / 15 mm due to height differences, the robot may enter but not exit the room, 

    potentially becoming trapped. In such cases, set up a "No-Go Zone" or "Virtual Wall" for this room as instructed on page 39 to prevent the robot from being trapped in this room.

9. The robot may not operate on certain darker black-colored surfaces because the anti-drop sensors, which recognize an edge or a stair, may perceive the black color as an edge, causing the robot to avoid cleaning over it.

10. Avoid cleaning high-pile rugs thicker than 0.78 in/20 mm, as they may cause Robot to malfunction.

11. While your robot is cleaning, do not pick it up and move it, or move the charging station this could impact the robot's ability to map your home or back to charging station.

12. Please don’t put any toy or other things near Laser Distance Sensor (LDS), these would block laser signal and influence Robot navigation.

Model: L8000 Plus/L8000 Pro